Hi to everyone,
I have a question: How can I simulate ALT+ENTER key pressing in qb code ?
I tried _SCREENPRINT statement but it seems to work (I have not tested all the combination like _screenprint chr$("ALT code number")+chr$(13)
I'don't know the ALT code in screenprint mode (if it exists), normally for ALT detection the code is chr$(0)+chr$(56), if I'm not mistaken...
Waitin' for your clues....
If you have questions about any aspect of QBasic programming, or would like to help fellow programmers solve their problems, check out this board!
1 post • Page 1 of 1