How to revive a Ryobi 18 volt lithium battery. Quick and easy

Discuss whatever you want here--both QB and non-QB related. Anything from the DEF INT command to the meaning of life!
Post Reply
User avatar
burger2227
Veteran
Posts: 2466
Joined: Mon Aug 21, 2006 12:40 am
Location: Pittsburgh, PA

How to revive a Ryobi 18 volt lithium battery. Quick and easy

Post by burger2227 »

How to revive a Ryobi 18 volt lithium battery. Quick and easy

Just drill two holes into the sides where the metal poles are and charge up battery
to over 5 volts and it should now work in your Ryobi charger again.

This procedure could work with other Lithium batteries also by taking them apart
to locate the battery poles inside. A board circuit may stop the battery from being
charged when the initial battery voltage is too low.

The batteries are made up of several 18650 lithium batteries in series...

My particular battery refused to be charged after power to the charger went off
and later resumed. It worked perfectly up until then...
Please acknowledge and thank members who answer your questions!
QB64 is a FREE QBasic compiler for WIN, MAC(OSX) and LINUX : https://www.qb64.org/forum/index.php
Get my Q-Basics demonstrator: https://www.dropbox.com/s/fdmgp91d6h8ps ... s.zip?dl=0
Post Reply