LED remote control

Discuss whatever you want here--both QB and non-QB related. Anything from the DEF INT command to the meaning of life!

Moderators: Pete, Mods

Post Reply
User avatar
Posts: 2466
Joined: Mon Aug 21, 2006 12:40 am
Location: Pittsburgh, PA

LED remote control

Post by burger2227 »

I recently bought 2 LED remote controllers from Ebay for less than $10:

The controller allows dimming and blinking at different speeds in addition to dimming on and off:
Voltage is limited to 5 to 24 volts. The LED's may need current limiting resistors in some cases, but it can handle currents
up to 12 amps for Christmas lights. The remotes are frequency matched to the controller and require a CR2025 battery.

I used some male and female 12 volt screw on connectors to test them on an existing temporary LED
sink light I made using 12 10mm LED's that normally is controlled by a touch switch under the sink cabinets.
Since each 10mm bright LED uses 3 volts, I made rows of 4 in series and ran 3 rows in parallel. I just taped it all up!
Please acknowledge and thank members who answer your questions!
QB64 is a FREE QBasic compiler for WIN, MAC(OSX) and LINUX : https://www.qb64.org/forum/index.php
Get my Q-Basics demonstrator: https://www.dropbox.com/s/fdmgp91d6h8ps ... s.zip?dl=0
Post Reply